Protocol Settings - SNMP

On the [SNMP] page, you can set the parameters for SNMP.

Community Name (Read Only)
Enter the community name used for read-only access, using single-byte alphanumeric characters/symbols (ASCII characters) within 31 bytes. The default is "public".
Even when the community name is already set, it does not appear on the screen. If you leave this blank, the community name set previously will be retained.

Community Name (Read/Write)
Enter the community name used for read-write access, using single-byte alphanumeric characters/symbols (ASCII characters)within 31 bytes.
Even when the community name is already set, it does not appear on the screen. If you leave this blank, the community name set previously will be retained.

Community Name (Trap Notification)
Enter the community name used for traps, using single-byte alphanumeric characters/symbols (ASCII characters) within 31 bytes. The default is "SNMP_trap".
Even when the community name is already set, it does not appear on the screen. If you leave this blank, the community name set previously will be retained.

[Apply] button
[Undo] button