Protocol Settings - SNMP

On the [SNMP] page, you can set the parameters for SNMP.

Community Name (Read Only)
Enter the community name used for read-only access within 31 single-byte characters. The default is "public".
Even when the community name is already set, it does not appear on the screen. If you leave this blank, the community name set previously will be retained.

Community Name (Read/Write)
Enter the community name used for read-write access within 31 single-byte characters.
Even when the community name is already set, it does not appear on the screen. If you leave this blank, the community name set previously will be retained.

Community Name (Trap Notification)
Enter the community name used for traps within 31 single-byte characters. The default is "SNMP_trap".
Even when the community name is already set, it does not appear on the screen. If you leave this blank, the community name set previously will be retained.

[Apply New Settings] button
[Restore Settings] button
[Refresh] button