Protocol Settings - SNMP
This page allows you to configure the settings for SNMP.
[Trap Notification (IPX)] does not appear if your printer does not support IPX/SPX.
Community Name (Read Only)
Enter the community name used for read-only access. You can enter a maximum of 31 bytes. The default is "public".
Community Name that has already been set will not be displayed on the window. The original setting will remain valid if no entry is made.
Community Name (Read/Write)
Enter the community names for read-write access. You can enter a maximum of 31 bytes.
Community Name that has already been set will not be displayed on the window. The original setting will remain valid if no entry is made.
Community Name (Trap Notification)
Enter the community name used for traps. You can enter a maximum of 31 bytes. The default is SNMP_trap.
Community Name that has already been set will not be displayed on the window. The original setting will remain valid if no entry is made.
Trap Notification (IP) 1-3
Notifies trap occurrences if the [Notify] check box is selected. If the check box is selected, enter the IP address and IP socket in the "aaa.bbb.ccc.ddd:eeeee" format. The "aaa", "bbb", and "ccc" must be the numbers between 0 and 255. However, "aaa" cannot be 127 or any number between 224 and 254. The "eeeee" (IP socket) must be any number between 0 and 65535.
If the check box is not selected, trap occurrences will not be notified, and the IP address you entered will reset to the default (0.0.0.0:0) when saved. The [Notify] check box is not selected by default.
Authentication Error Trap
Select the [Notify] check box to notify authentication error traps.
Trap Notification (IPX)
Notifies trap occurrences if the [Notify] check box is selected. If the check box is selected, enter the IPX address in the "aaaaaaaa:bbbbbbbbbbbb:cccc" format. IPX network, "aaaaaaaa", must be a hexadecimal value between 0 and "ffffffff". The IPX node, "bbbbbbbbbbbb", must be a hexadecimal value between 0 and "ffffffffffff". And the IPX socket, "cccc" must be a hexadecimal value between 0 and "ffff".
If the check box is not selected, trap occurrences will not be notified, and the IPX address you entered will reset to the default (00000000:000000000000:0000) when saved. The [Notify] check box is not selected by default.
[Apply] button
[Undo] button