[SNMP v1/v2]

Note

This setting takes effect after the printer is restarted from CentreWare Internet Services, or is turned off and then on again from the printer's control panel.

[Enable]

Set whether to enable SNMP v1/v2c.

[Allow Write]

Set whether to allow clients to write to data when they access data.

[Community Names]

This item is displayed when SNMP v1/v2c is enabled.

[Community Name (Read Only)]

Enter a read-only community name.

[Community Name (Read / Write)]

Enter a read/write community name.

[Trap Community Name]

Enter the community name used when traps are sent.

[System Administrator Name]

Set information about the person responsible for maintenance of the printer.

[Trap Destination]

This item is displayed when SNMP v1/v2c is enabled.

Lists the members to which traps are sent. Clicking a member or [(Not Registered] displays the dialog box for editing traps.

[Edit Trap 1] to [Edit Trap 8] Dialog Boxes

[SNMP Version]

Set the SNMP version.

[Address Type]

Set the type of destination addresses to which traps are sent.

[IP Address]

Enter the IP address or host name, and the port number (UDP).

[Traps Community Name]

Set the community name used when traps are sent. Enter a string within 32 characters using JIS-X0201 (ROMAN) and Kana characters.

[Traps to be Received]

For each item, set whether to notify of the occurrence of traps.

∧