Protocol Settings - SMB

This page allows you to configure the settings for SMB.
This item does not appear if your printer does not support SMB.
The following settings will become valid after rebooting the printer from CentreWare Internet Services or manually switching it off and then on again.

Host Name
Enter the host name within 15 bytes. The characters that can be entered include alphanumeric characters and hyphens (-).

Workgroup
Enter the name of the workgroup within 15 bytes. The characters that can be entered include alphanumeric characters and the following symbols:
! # $ @ % & ( ) - . ^ _ { } ~ ' / `

Maximum Number of Sessions
Displays the maximum number of sessions.

Unicode Support
Set whether or not to notify the host name and workgroup name in Unicode characters during SMB transmission.

Auto Master Mode
Set whether or not to enable Auto Master Mode. When NIC is restarted, the system searches for the browse master (a device that manages the device host names in a workgroup) in its workgroup. If the browse master could not be found when Auto Master Mode is [Enabled], NIC will become the browse master.

Password Encryption
Set whether or not to encrypt the password during SMB transmission.

Print Time-Out
Use the default value (600 seconds). This setting should not be changed in normal circumstances.

Non-print Time-Out
Use the default value (180 seconds). This setting should not be changed in normal circumstances.

[Apply] button
[Undo] button