Port Settings - Ethernet

This page allows you to configure your Ethernet settings.

Ethernet Settings
Select the transmission speed of Ethernet from the following.
This setting will become active after rebooting the printer. You can reboot the printer from CentreWare Internet Services or by manually turning the printer off and on.
If the optional hard disk unit is not installed on your printer, note that the data in the memory is cleared when the printer is turned off.


• Auto
  Automatically detects and switches the Ethernet transmission speed and Duplex setting.
  
  
• 10Base-T Half-Duplex
  Sets the transmission speed to 10Base-T Half-Duplex.
  
  
• 10Base-T Full-Duplex
  Sets the transmission speed to 10Base-T Full-Duplex.
  
  
• 100Base-TX Half-Duplex
  Sets the transmission speed to 100Base-TX Half-Duplex.
  
  
• 100Base-TX Full-Duplex
  Sets the transmission speed to 100Base-TX Full-Duplex.
  
  
• 1000Base-T Full-Duplex
  Sets the transmission speed to 1000Base-T Full-Duplex.
  

Current Ethernet Settings
Displays the current Ethernet transmission speed.
Since the current value of Ethernet depends on the operation specification of the network stack, the current value and the set value may differ.

MAC Address
Displays the MAC address. This is a display-only item.

[Apply] button
[Undo] button