Port Status

This page allows you to enable or disable each port. Set all ports you want to use to [Enabled].

The ports displayed differ depending on the model of your printer and the options installed.
The following settings will become active after rebooting the printer from CentreWare Internet Services or manually turning off and on the printer.
If the optional hard disk unit is not installed on your printer, note that the data in the memory is cleared when the printer is turned off.

LPD
Select [Enabled] to use the LPD port.

Port9100
Select [Enabled] to use the Port9100 port.

IPP
Select [Enabled] to use the IPP port.

WSD Print
Select [Enabled] to use the WSD Print port.
WSD stands for Web Services on Devices.

FTP
Select [Enabled] to use the FTP port.

SMB
Select [Enabled], and configure the transport protocol to be used. [TCP/IP] and [NetBEUI] can be selected simultaneously as the transport protocol.

Bonjour
Select [Enabled] to use Bonjour.

Telnet
Select [Enabled] to use Telnet.

SNMP
Select [Enabled] to use SNMP.

StatusMessenger
Select [Enabled] to use StatusMessenger.

SNTP
Select [Enabled] to use SNTP.

[Apply] button
[Undo] button